Don 2 Drive-In

Memorial Boulevard and Highway 73,
Port Arthur, TX 77640

Unfavorite 1 person favorited this theater

Showing 8 comments

Cherilyn
Cherilyn on July 21, 2022 at 5:53 am

Wish I could have gone there I have never been to a drive in movie in my life

MichaelKilgore
MichaelKilgore on April 18, 2020 at 11:04 pm

Billboard, Nov. 22, 1952: “O. O. Cummings has sold the 500-car-capacity Don Drive-In Theater at Port Arthur, Tex., to Jefferson Amusement Company, with headquarters at Beaumont, Tex.”

MichaelKilgore
MichaelKilgore on March 29, 2019 at 4:17 pm

From the Sept. 10, 1955 issue of Billboard:

“A new second screen has been installed at the Don Drive-In, Port Arthur, Tex. New lamps were also recently installed.”

jwmovies
jwmovies on September 27, 2012 at 8:55 am

5500 does not map properly. Approx. location for this drive-in was on Memorial Blvd. between Hwy 73 and 60th St. The entrance is still there and you can make out the outlines for both theatres. You can see where the snack bar was also.

TLSLOEWS
TLSLOEWS on March 13, 2011 at 9:17 pm

I agree even in the late seventies we ran 20 miniute reels,until we got the bigger reels and could put 3 reels on one and only change over every hour.We also still used carbon arc lamphouses except at the Loews Madison which had xenon bulbs.Xenon was not a bright picture and if the went out they could not be relit as you could with the carbon rods.

Mike Rogers
Mike Rogers on May 22, 2010 at 4:43 am

If you had those old carbon arcs in theatres with cue marks and change overs there would much fewer complaints about movies today when a trained and usually a union man is in the booth,and not some 17 year old kid trying to figure out how to score with"SUSIE" the candy girl. Right on Norelco.

stevendm
stevendm on April 22, 2009 at 2:54 am

I consider this projection setup unusual for the late 1970’s because each projector would only hold a double reel of film, running for about 20 minutes. I worked as a projectionist in five theaters in the Beaumont / Port Arthur area and this was the only one that could not hold a large reel (about one hour run time) or platters, which held the entire movie. It was only one of two theaters in the area that used carbon arc lamps, the rest using xenon. BTW, I never could get the carbon arc lamps to stop their slight flickering. I could notice it but I doubt most theater goers could (I bet I will be proven wrong on that statement).

carolgrau
carolgrau on April 11, 2009 at 4:13 am

What is unusual about that? That is what is called real projection. I remember when we went xenon, after one lamp was installed we wanted to see the difference. We left the xenon lit, then fired up the old Strong Futura II, the carbon knocked the xenon light right off the screen. Carbons was by far a much better light source but they became so high in cost xenon was the only way to go.